Starting replication using automatic synchronization


Starting replication using automatic synchronization
Prev	Configuring a global SFCFSHA cluster using Veritas Volume Replicator (VVR): starting replication	Next

Use the vradmin command to start replication or the transfer of data from the primary site to the secondary site over the network. Because the cluster on the secondary site uses only one host name, the command does not require the sec_host argument.

To start replication using automatic synchronization

From the primary site, use the following command to automatically synchronize the RVG on the secondary site:
```
vradmin -g disk_group -a startrep pri_rvg sec_host
					
```
where:
- disk_group is the disk group on the primary site that VVR will replicate
- pri_rvg is the name of the RVG on the primary site
- sec_host is the virtual host name for the secondary site
For example:
```
# vradmin -g oradatadg -a startrep rac1_rvg
							clus2
						
```