Starting and stopping processes for the Symantec products
After the installation and configuration is complete, the Symantec product installer starts the processes that the installed products use. You can use the product installer to stop or start the processes, if required.
To stop the processes
- Use the -stop option to stop the product installation script.
For example, to stop the product's processes, enter the following command:
# ./installer -stop
or
# /opt/VRTS/install/installsfcfsha<version> -stop
Where <version> is the specific release version.
See About the script-based installer.
To start the processes
- Use the -start option to start the product installation script.
For example, to start the product's processes, enter the following command:
# ./installer -start
or
# /opt/VRTS/install/installsfcfsha<version> -start
Where <version> is the specific release version.
See About the script-based installer.
