 | ||
| Configuring the CP server cluster in secure mode | ||
|---|---|---|
| Prev | Setting up the CP server | Next |
You must configure security on the CP server only if you want IPM-based (Symantec Product Authentication Service) secure communication between the CP server and the SFHA cluster (CP server clients). However, IPM-based communication enables the CP server to support application clusters prior to release 6.1.
This step secures the HAD communication on the CP server cluster.
Note: |
If you already configured the CP server cluster in secure mode during the VCS configuration, then skip this section. |
To configure the CP server cluster in secure mode
If you have VCS installed on the CP server, run the following command:
# /opt/VRTS/install/installvcs<version> -security
Where <version> is the specific release version.
If you have SFHA installed on the CP server, run the following command:
# /opt/VRTS/install/installsfha<version> -security
Where <version> is the specific release version.