Configuring the CP server using the web-based installer
Perform the following steps to configure the CP server using the web-based installer.
To configure Storage Foundation Cluster File System High Availability on a cluster
- Start the web-based installer.
See Starting the web-based installer.
- On the Select a task and a product page, select the task and the product as follows:
Click .
- On the Select Cluster page, enter the system names where you want to configure Storage Foundation Cluster File System High Availability and click .
- In the Confirmation dialog box, verify cluster information is correct and choose whether or not to configure CP server.
To configure CP server, click .
To configure CP server later, click .
- On the Select Option page, select Configure CP Server on a single-node VCS system or SFHA cluster and click .
- On the Configure CP Server page, provide CP server information, such as, name, virtual IPs, port numbers, and absolute path of the database to store the configuration details.
Click .
- Configure the CP Server Service Group (CPSSG), select the number of NIC resources, and associate NIC resources to virtual IPs that are going to be used to configure the CP Server.
Click .
- Configure network hosts for the CP server.
Click .
- Configure disk group for the CP server.
Click .
Note: |
This step is not applicable for a single node cluster. |
- Configure volume for the disk group associated to the CP server.
Click .
Note: |
This step is not applicable for a single node cluster. |
- Click to complete configuring the CP server.