The SmartIO feature enables you to disable or enable caching for a specific file system. For a cluster file system, you must run the commands on each node in the cluster.
Enabling or disabling caching for a file system is not persistent when the cache area is brought offline and online, or when you shrink a cache area. In this case, the caching for the file system depends on the caching mode set on the mount point or set with the sfcache set mode command. To make the caching status persistent, use the sfcache set mode command.
See Setting or changing the caching mode for a VxFS cache area.
To purge the caching data for a file system
# sfcache purge {mount_point|fsuuid}
Where:
mount_point is the mount point for the file system.
fsuuid specifies the UUID of the file system. Specify the fsuuid to purge the caching data for a file system that is not mounted.