Review the following guidelines for setting the media speed of the LLT interconnects:
Symantec recommends that you manually set the same media speed setting on each Ethernet card on each node.
If you have hubs or switches for LLT interconnects, then set the hub or switch port to the same setting as used on the cards on each node.
If you use directly connected Ethernet links (using crossover cables), set the media speed to the highest value common to both cards, typically 100_Full_Duplex.
Symantec does not recommend using dissimilar network cards for private links.
Details for setting the media speeds for specific devices are outside of the scope of this manual. Consult the device's documentation for more information.