The system you add to the cluster must meet the hardware and software requirements.
Table: Tasks that are involved in adding a node to a cluster specifies the tasks that are involved in adding a cluster. The example demonstrates how to add a node saturn to already existing nodes, galaxy and nebula.
Table: Tasks that are involved in adding a node to a cluster
Task |
Reference |
---|---|
Set up the hardware. |
|
Install the software manually and add a license key. |
See Installing the VCS software manually when adding a node. |
For a cluster that is running in secure mode, verify the existing security setup on the node. |
|
Configure LLT and GAB. |
|
Add the node to the existing cluster. |
|
Start VCS and verify the cluster. |