To modify the configuration files on a remaining node

1. If necessary, modify the /etc/gabtab file.

   No change is required to this file if the /sbin/gabconfig command has only the argument -c. Symantec recommends using the -nN option, where N is the number of cluster systems.

   If the command has the form /sbin/gabconfig -c -nN, where N is the number of cluster systems, make sure that N is not greater than the actual number of nodes in the cluster. When N is greater than the number of nodes, GAB does not automatically seed.

   Note:

   Symantec does not recommend the use of the -c -x option for /sbin/gabconfig.

2. Modify /etc/llthosts file on each remaining nodes to remove the entry of the departing node.

   For example, change:

   0 galaxy	
   1 nebula
   2 saturn

   To:

   0 galaxy
   1 nebula