Section I Cluster Management Console basics
Chapter 1 Getting acquainted with the Cluster Management Console
Chapter 2 Concepts, components, and architecture
About Cluster Management Console software components
Objects in the Cluster Management Console
Object states and consolidated states
Symantec Product Authentication Service
Section II Administering VCS clusters in the enterprise
Chapter 3 Getting started with the Cluster Management Console
Connecting to the Cluster Management Console
Logging in to the Cluster Management Console
Chapter 4 Administering multiple clusters and the management server
Adding a cluster using direct connection
Removing a direct connection cluster
Chapter 5 Administering reports
Running a report job to generate a report output
Enabling and disabling report jobs
Chapter 6 Administering notification
Chapter 7 Searching the database
Chapter 8 Administering the database
Viewing information about the database
Section III Appendixes
Appendix A Command line interface
Introduction to the command line interface
Notations for object names in the CLI
Appendix B Creating custom reports
Accessing the database information
Database schema object descriptions
Published database schema objects
Appendix C Accessibility
Appendix D Troubleshooting
Installation issues and recommendations
Avoid concurrent installations
Cluster connector upgrade fails when using cc_configure.sh
Exception message during management server upgrade
Specifying host names with installcmc causes failure
Symantec Product Authentication Service post-upgrade versions
Configuration issues and recommendations
Cluster configuration state after cluster user addition
The cluster connector, direct connection, and DNS configuration
Using direct connection with clusters configured in secure mode
Operational issues and recommendations
Cluster Management Console controls not immediately active
Cluster status is off line during snapshot
Very large clusters may not load into the console
User issues and recommendations
Console display issues and recommendations
Attributes added in VCS CLI may not display as expected
Table blank but filter panels report service groups
Random characters displayed on https login