Performing Exchange Server installation: additional nodes


Performing Exchange Server installation: additional nodes
Prev	Installing Exchange 2007 on additional nodes	Next

Install Exchange on the node where the Exchange Setup Wizard was run for the pre-installation tasks. This is a standard Microsoft Exchange Server installation.

Refer to the Microsoft documentation for details on this installation.

While installing Exchange, note the following:

Install the same Exchange version and components on all nodes.
HA support for Exchange Server 2007 is available for the Mailbox Server role. While installing Exchange, ensure that you install the Mailbox Server role only.

To install Exchange

Begin the Exchange installation for disaster recovery at the command prompt using RecoverServer as the install mode:
```
<drive letter>:\setup.com /mode:recoverserver
```
Here <drive letter> is the location where the Exchange software is located.
Setup copies the setup files locally to the computer on which you are installing Exchange 2007 and then checks the prerequisites, including all prerequisites specific to the server roles that you are installing. If you have not met all of the prerequisites, Setup fails and returns an error message that explains the reason for the failure. If you have met all of the prerequisites, Setup installs Exchange 2007.
Verify that the installation completed successfully.
Refer to the Microsoft documentation for more information.

Prev	Up	Next
Performing Exchange pre-installation: additional nodes	Home	Performing Exchange post-installation: additional nodes