If you want to configure LLT to use aggregated interfaces after installing and configuring VCS, you can use one of the following approaches:
Edit the /etc/llttab file
This approach requires you to stop LLT. The aggregated interface configuration is persistent across reboots.
Run the lltconfig command
This approach lets you configure aggregated interfaces on the fly. However, the changes are not persistent across reboots.
To configure aggregated interfaces under LLT by editing the /etc/llttab file
# /etc/init.d/llt stop
See Stopping VCS.
link tag device_name systemid_range link_type sap mtu_size
# /etc/init.d/llt start
See Starting VCS.
To configure aggregated interfaces under LLT using the lltconfig command
lltconfig -t devtag -d device [-b linktype ] [-s SAP] [-m mtu]
See the lltconfig(1M) manual page for more details.
You need not reboot after you make this change. However, to make these changes persistent across reboot, you must update the /etc/llttab file.
See “To configure aggregated interfaces under LLT by editing the /etc/llttab file”.