Defines the number of times the meter operation can be retried before it succeeds. If MeterRetryLimit is set to 0, there is no limit on number of retries. If this attribute is set to a non-zero value and the meter entry point fails after the specified attempts, then the metering for that resource is disabled.
You can override this attribute at the resource level.
Default: 10
You can turn on metering in one of the following ways:
Veritas recommends to increase the MeterRetryLimit attribute value to a higher value using the following command:
If MeterRetryLimit is defined at type level, enter:
# hatype -modify type_name MeterRetryLimit new_value
If MeterRetryLimit is overridden at the resource level, enter:
# hares -modify res_name MeterRetryLimit new_value