You can configure global clusters to link clusters at separate locations and enable wide-area failover and disaster recovery. The installer adds basic global cluster information to the VCS configuration file. You must perform additional configuration tasks to set up a global cluster.
See the Cluster Server Administrator's Guide for instructions to set up VCS global clusters.
Note: |
If you installed a HA/DR license to set up replicated data cluster or campus cluster, skip this installer option. |
To configure the global cluster option
If you skip this option, the installer proceeds to configure VCS based on the configuration details you provided.
The installer prompts you for a NIC, a virtual IP address, and value for the netmask.
You can also enter an IPv6 address as a virtual IP address.