After you have configured LLT, GAB, and VCS, use the following procedures to start LLT, GAB, and VCS.
# /etc/init.d/llt start
If LLT is configured correctly on each node, the console output resembles:
Loading LLT Driver... Starting LLT: LLT: loading module... Loaded kernel_version on kernel kernel_version LLT: configuring module where, kernel_version is the kernel version of the Linux operating system
# /sbin/lltconfig LLT is running
# /etc/init.d/gab start
If GAB is configured correctly on each node, the console output resembles:
GAB: Starting GAB: Starting Done
# /sbin/gabconfig -a GAB Port Memberships =================================== Port a gen a36e0003 membership 01
# /etc/init.d/vcs start
If VCS is configured correctly on each node, the engine log file at /var/VRTSvcs/log/engine_A.log
resembles:
VCS NOTICE V-16-1-10619 'HAD' starting on: sys1 VCS NOTICE V-16-1-10620 Waiting for local cluster configuration status VCS NOTICE V-16-1-10625 Local cluster configuration valid VCS NOTICE V-16-1-11034 Registering for cluster membership VCS NOTICE V-16-1-11035 Waiting for cluster membership GAB INFO V-15-1-20036 Port h gen 265f06 membership ;1 GAB INFO V-15-1-20038 Port h gen 265f06 k_jeopardy 0 GAB INFO V-15-1-20040 Port h gen 265f06 visible 0 VCS INFO V-16-1-10077 Received new cluster membership VCS NOTICE V-16-1-10082 System (sys1) is in Regular Membership - Membership: 0x2 VCS NOTICE V-16-1-10073 Building from local configuration VCS NOTICE V-16-1-10066 Entering RUNNING state GAB INFO V-15-1-20036 Port h gen 265f07 membership 01 VCS INFO V-16-1-10077 Received new cluster membership VCS NOTICE V-16-1-10082 System (sys2) is in Regular Membership - Membership: 0x3