Perform the following tasks on each of the remaining nodes of the cluster.
To modify the configuration files on a remaining node
No change is required to this file if the /sbin/gabconfig command has only the argument -c. Veritas recommends using the -nN option, where N is the number of cluster systems.
If the command has the form /sbin/gabconfig -c -nN, where N is the number of cluster systems, make sure that N is not greater than the actual number of nodes in the cluster. When N is greater than the number of nodes, GAB does not automatically seed.
Veritas does not recommend the use of the -c -x option for /sbin/gabconfig.
For example, change:
0 sys1 1 sys2 2 sys5
To:
0 sys1 1 sys2