Unloading LLT and GAB and removing Veritas InfoScale Availability or Enterprise on the departing node

Perform the tasks on the node that is departing the cluster.

You can use script-based installer to uninstall Veritas InfoScale Availability or Enterprise on the departing node or perform the following manual steps.

If you have configured VCS as part of the InfoScale products, you may have to delete other dependent RPMs before you can delete all of the following ones.

To stop LLT and GAB and remove Veritas InfoScale Availability or Enterprise

  1. If you had configured I/O fencing in enabled mode, then stop I/O fencing.
    # /etc/init.d/vxfen stop
  2. Stop GAB and LLT:
    # /etc/init.d/gab stop
    # /etc/init.d/llt stop
  3. To determine the RPMs to remove, enter:
    # rpm -qa |grep VRTS
  4. To permanently remove the Availability or Enterprise RPMs from the system, use the rpm -e command. Start by removing the following RPMs, which may have been optionally installed, in the order shown:
    # rpm -e VRTSsfcpi
    # rpm -e VRTSvcswiz
    # rpm -e VRTSvbs
    # rpm -e VRTSsfmh
    # rpm -e VRTSvcsea
    # rpm -e VRTSvcsdr
    # rpm -e VRTSvcsag
    # rpm -e VRTScps
    # rpm -e VRTSvcs
    # rpm -e VRTSamf
    # rpm -e VRTSvxfen
    # rpm -e VRTSgab
    # rpm -e VRTSllt
    # rpm -e VRTSspt
    # rpm -e VRTSvlic
    # rpm -e VRTSperl		
  5. Remove the LLT and GAB configuration files.
    # rm /etc/llttab
    # rm /etc/gabtab
    # rm /etc/llthosts