To clear Fault state

When you fix an application fault on a system, you must further clear the application Faulted state on that system. Unless you clear the Faulted state, VCS cannot failover the application on that system.

You can use the Veritas High Availability view to clear this faulted state at the level of a configured application component (resource).

The Clear Fault link is automatically dimmed if there is no faulted system in the cluster.

To clear Fault state

  1. In the appropriate row of the application table, click More > Clear Fault state.
  2. In the Clear Fault State panel, click the system where you want to clear the Faulted status of a component, and then click OK.