To verify the server-based I/O fencing configuration

1. Verify that the I/O fencing configuration was successful by running the vxfenadm command. For example, run the following command:

   # vxfenadm -d

   Note:

   For troubleshooting any server-based I/O fencing configuration issues, refer to the Cluster Server Administrator's Guide.

2. Verify that I/O fencing is using the specified coordination points by running the vxfenconfig command. For example, run the following command:

   # vxfenconfig -l

   If the output displays single_cp=1, it indicates that the application cluster uses a CP server as the single coordination point for server-based fencing.