Modifying a cluster panel configuration
Prev Administering Cluster Monitor Next

Modifying a cluster panel configuration

Modify a cluster panel to point to another cluster, to change the port number, or the number of failover retries.

  1. If Cluster Monitor is in the default expanded state, proceed to step 2. If Cluster Monitor is in the collapsed state:

    On the View menu, click Expand.

    or

    On the View menu, click Stop when an active panel appears as the view panel.

  2. Right-click the cluster panel. If the panel is inactive, proceed to step 4.
  3. On the menu, click Logout. The cluster panel becomes inactive.
  4. Right-click the inactive panel, and click Configure...
  5. Edit the details to connect to the cluster:

    • Enter the host name or IP address of any system in the cluster.

    • Enter the port number and the number of failover retries. VCS sets the default port number to 14141 and failover retries number to 12; VCS Simulator uses a default port number of 14153.

    • For simulated panels, click the platform for the configuration.

    • Click OK.

Prev Up Next
Configuring a new cluster panel Home Logging on to a cluster and logging off