The Java Console provides several ways to add a resource to a service group. Use Cluster Explorer or Command Center to perform this task.
To add a resource from Cluster Explorer
or
Click Add Resource in the Cluster Explorer toolbar.
Enter the details of the resource:
Enter the name of the resource.
Click the resource type.
Edit resource attributes according to your configuration. The Java Console also enables you to edit attributes after adding the resource.
Select the Critical and Enabled check boxes, if applicable. The Critical option is selected by default.
A critical resource indicates the service group is faulted when the resource, or any resource it depends on, faults. An enabled resource indicates agents monitor the resource; you must specify the values of mandatory attributes before enabling a resource. If a resource is created dynamically while VCS is running, you must enable the resource before VCS monitors it. VCS will not bring a disabled resource nor its children online, even if the children are enabled.
Click Show Command in the bottom left corner to view the command associated with the resource. Click Hide Command to close the view of the command.
Click OK.
To add a resource from Command Center
or
Click Add resource in the Command Center toolbar.
A critical resource indicates the service group is faulted when the resource, or any resource it depends on, faults. An enabled resource indicates agents monitor the resource; you must specify the values of mandatory attributes before enabling a resource. If a resource is created dynamically while VCS is running, you must enable the resource before VCS monitors it. VCS will not bring a disabled resource nor its children online, even if the children are enabled.
To add a resource from the Template view