About the resfault event trigger

The following table describes the resfault event trigger:

Description

Invoked on the system where a resource has faulted. Note that when a resource is faulted, resources within the upward path of the faulted resource are also brought down.

This event trigger is configurable.

To configure this trigger, you must define the following:

TriggerResFault: Set the attribute to 1 to invoke the trigger when a resource faults.

Usage

-resfault triggertype system resource previous_state

triggertype - represents whether trigger is custom (triggertype=0) or internal (triggertype=1).

For this trigger, triggertype=0.

system - represents the name of the system.

resource - represents the name of the faulted resource.

previous_state - represents the resource's previous state.

To enable the trigger

To invoke the trigger when a resource faults, set the TriggerResFault attribute to 1.