The vxdmpadm utility is a command-line administrative interface to Dynamic Multi-Pathing (DMP).
Retrieve the name of the DMP device corresponding to a particular path.
Display consolidated information about the DMP nodes.
Display the members of a LUN group.
List all paths under a DMP device node, HBA controller, enclosure, or array port.
Display information about the HBA controllers on the host.
Display information about enclosures.
Display information about array ports that are connected to the storage processors of enclosures.
Display information about devices that are controlled by third-party multi-pathing drivers.
Display extended devices attributes.
Suppress or include devices from DMP control.
Gather I/O statistics for a DMP node, enclosure, path, or controller.
Configure the attributes of the paths to an enclosure.
Display the redundancy level of a device or enclosure.
Specify the minimum number of active paths.
Display or set the I/O policy that is used for the paths to an enclosure.
Enable or disable I/O for a path, HBA controller or array port on the system.
Rename an enclosure.
Configure how DMP responds to I/O request failures.
Configure the I/O throttling mechanism.
Control the operation of the DMP path restoration thread.
Configure array policy modules.
Get or set the values of various tunables used by DMP.
See the vxdmpadm(1M) manual page.