Configuring server-based fencing on the SFCFSHA cluster manually

The configuration process for the client or SFCFSHA cluster to use CP server as a coordination point requires editing the /etc/vxfenmode file.

You need to edit this file to specify the following information for your configuration:


Whenever coordinator disks are used as coordination points in your I/O fencing configuration, you must create a disk group (vxfencoorddg). You must specify this disk group in the /etc/vxfenmode file.

See Setting up coordinator disk groups.

The customized fencing framework also generates the /etc/vxfentab file which has coordination points (all the CP servers and disks from disk group specified in /etc/vxfenmode file).

To configure server-based fencing on the SFCFSHA cluster manually

  1. Use a text editor to edit the following file on each node in the cluster:


    You must change the values of the VXFEN_START and the VXFEN_STOP environment variables to 1.

  2. Use a text editor to edit the /etc/vxfenmode file values to meet your configuration specifications.
    • If your server-based fencing configuration uses a single highly available CP server as its only coordination point, make sure to add the single_cp=1 entry in the /etc/vxfenmode file.

    • If you want the vxfen module to use a specific order of coordination points during a network partition scenario, set the vxfen_honor_cp_order value to be 1. By default, the parameter is disabled.

    The following sample file output displays what the /etc/vxfenmode file contains:

    See Sample vxfenmode file output for server-based fencing.

  3. After editing the /etc/vxfenmode file, run the vxfen init script to start fencing.

    For example:

    # svcadm enable vxfen