Configuring application and replication for global cluster setup

Perform the following steps to configure application at the secondary site. This procedure assumes that you have already set up application for high availability at the primary site.

To configure application and replication

  1. At the secondary site, install and configure the application that you want to make highly available.

    See the corresponding application documentation for instructions.

  2. At each site, set up data replication using a replication technology that VCS supports:

    • Volume Replicator

      See the Veritas InfoScale 7.1 Installation Guide and the Veritas InfoScale 7.1 Replication Administrator's Guide for instructions.

    • A supported third-party replication technology

      See the corresponding replication documentation for instructions. See the High Availability Agent Pack Getting Started Guide for a list of third-party replication technologies that VCS supports.