State transitions with respect to ManageFaults attribute


State transitions with respect to ManageFaults attribute
Prev	State transition diagram	Next

This section shows state transition diagrams with respect to the ManageFault attribute.

By default, ManageFaults is set to ALL, in which case the clean entry point is called by VCS.

The diagrams cover the following conditions:

Bringing a resource online when the ManageFaults attribute is set to NONE
Taking a resource offline when the ManageFaults attribute is set to NONE
Resource fault when ManageFaults attribute is set to ALL
Resource fault (unexpected offline) when ManageFaults attribute is set to NONE
Resource fault (monitor is hung) when ManageFaults attribute is set to ALL
Resource fault (monitor is hung) when ManageFaults attribute is set to NONE

Figure: Bringing a resource online: ManageFaults attribute = NONE

Figure: Taking a resource offline; ManageFaults = None

Figure: Resource fault (unexpected offline): ManageFaults attribute = NONE

Figure: Resource fault (monitor hung): ManageFaults attribute = NONE