The installer prompts for the system names on which you want to configure VCS. The installer performs an initial check on the systems that you specify.
To specify system names for configuration
Enter the operating_system system names separated by spaces: [q,?] (sys1) sys1 sys2
The installer does the following tasks:
Checks that the local node running the installer can communicate with remote nodes
If the installer finds ssh binaries, it confirms that ssh can operate without requests for passwords or passphrases. If ssh binaries cannot communicate with remote nodes, the installer tries rsh binaries. And if both ssh and rsh binaries fail, the installer prompts to help the user to setup ssh or rsh binaries.
Makes sure that the systems are running with the supported operating system
Checks whether Veritas InfoScale Enterprise is installed
Exits if Veritas InfoScale Enterprise7.3 is not installed
Review the installer output about the I/O fencing configuration and confirm whether you want to configure fencing in enabled mode.
Do you want to configure I/O Fencing in enabled mode? [y,n,q,?] (y)