Bringing the Sybase service group online

Perform the following steps to bring a service group online. Note that in the initial few cycles of bringing a service group online, the memory usage by the agent can spike.

To bring a service group online

  1. From Cluster Explorer, click the Service Groups tab in the configuration tree.
  2. Right-click the service group and click Enable Resources to enable all the resources in this group.
  3. Right-click the service group, hover over Enable, and select either the node or all the nodes where you want to enable the service group.
  4. Save and close the configuration. Click File > Save Configuration, then Close Configuration.
  5. Right-click the service group, pause over Online, and select the system where you want to bring the service group online.