The broadcast address is set explicitly for each link in the following example.

• Display the content of the /etc/llttab file on the first node sys1:

  sys1 # cat /etc/llttab

  set-node sys1
  set-cluster 1
  link link1 udp - udp  50000  -  192.168.9.1 192.168.9.255
  link link2 udp - udp  50001  -  192.168.10.1 192.168.10.255

  Verify the subnet mask using the ifconfig command to ensure that the two links are on separate subnets.

• Display the content of the /etc/llttab file on the second node sys2:

  sys2 # cat /etc/llttab

  set-node sys2
  set-cluster 1
  link link1 udp - udp  50000  -  192.168.9.2 192.168.9.255
  link link2 udp - udp  50001  -  192.168.10.2 192.168.10.255

  Verify the subnet mask using the ifconfig command to ensure that the two links are on separate subnets.