Starting the software configuration
Prev Configuring VCS Next

Starting the software configuration

You can configure VCS using the product installer.

Note:

If you want to reconfigure VCS, before you start the installer you must stop all the resources that are under VCS control using the hastop command or the hagrp -offline command.

To configure VCS using the product installer

  1. Confirm that you are logged in as a superuser.
  2. Start the configuration using the installer.
    # /opt/VRTS/install/installer -configure

    The installer starts the product installation program with a copyright message and specifies the directory where the logs are created.

  3. Select the component to configure.
  4. Continue with the configuration procedure by responding to the installer questions.
Prev Up Next
Overview of tasks to configure VCS using the product installer Home Specifying systems for configuration