You can configure the virtual IP of the cluster to use to connect from the Cluster Manager (Java Console), Veritas InfoScale Operations Manager, or to specify in the RemoteGroup resource.
See the Cluster Server Administrator's Guide for information on the Cluster Manager.
See the Cluster Server Bundled Agents Reference Guide for information on the RemoteGroup agent.
To configure the virtual IP of the cluster
Do one of the following:
If the discovered NIC is the one to use, press Enter.
If you want to use a different NIC, type the name of a NIC to use and press Enter.
Active NIC devices discovered on sys1: eth0 Enter the NIC for Virtual IP of the Cluster to use on sys1: [b,q,?](eth0)
Do one of the following:
If all nodes use the same public NIC, enter y.
If unique NICs are used, enter n and enter a NIC for each node.
Is eth0 to be the public NIC used by all systems [y,n,q,b,?] (y)
You can enter either an IPv4 address or an IPv6 address.
If you want to set up trust relationships for your secure cluster, refer to the following topics: