Perform the following steps to add a system to a Cluster Server (VCS) cluster by using the VCS Cluster Configuration wizard.
The system from where you launch the wizard must be part of the cluster to which you want to add a new system.
To add a system to a VCS cluster
The VCS Cluster Configuration Wizard is launched.
The Configuration Inputs panel appears, along with the cluster name, and a table of existing cluster systems.
To add another system to the cluster, click Add System and repeat step 4.
To modify the User name or Password for a cluster system, use the edit icon.
Click Next
Note: |
You cannot modify the existing type of cluster communication (LLT over Ethernet or LLT over UDP). |
If the existing cluster uses LLT over Ethernet, select the adapter for each network communication link. You must select a different network adapter for each communication link.
If the existing cluster uses LLT over UDP, select the type of IP protocol (IPv4 or IPv6), and then specify the required details for each communication link.
By default, one of the links is configured as a low-priority link on a public network interface. The other link is configured as a high-priority link.
To change a high-priority link to a low-priority link, click Modify. In the Modify low-priority link dialog box, select the link and click OK.
The wizard displays the status of the configuration task. After the configuration is complete, click Next.
If the configuration task fails, click Diagnostic information to check the details of the failure. Rectify the cause of the failure and run the wizard again to add the required system to the VCS cluster.