Setting up a node to join the single-node cluster

The new node to join the existing single node that runs VCS must run the same operating system.

To set up a node to join the single-node cluster

  1. Do one of the following tasks:

    • If VCS is not currently running on Node B, proceed to step 2.

    • If the node you plan to add as Node B is currently part of an existing cluster, remove the node from the cluster. After you remove the node from the cluster, remove the VCS RPMs and configuration files.

    • If the node you plan to add as Node B is also currently a single VCS node, uninstall VCS.

    • If you renamed the LLT and GAB startup files, remove them.

  2. If necessary, install VxVM and VxFS.

More Information

Removing a node from a VCS cluster

Installing VxVM or VxFS if necessary