Use this procedure to perform storage migration for SFW dynamic disk groups.
Ensure that the disk groups that you want to migrate are imported on the system where you run this procedure.
To migrate volumes belonging to SFW dynamic disk groups
Connect to the local system.
All selected source volumes can migrate to any target disks if the Select all volumes option is selected.
If you select the Select all volumes option, you do not have the option to change the layout. The layout can be changed only on selecting individual volumes.
If you select the Change layout check box and opt to change the layout of the volume, the target layout column gets populated with the selected layout, otherwise Unchanged is displayed.
Click Next to go to the Summary panel.
Unless the validation status of all the volumes shows Success, the GUI does not navigate to the next panel. The validation status column is populated when you click Next on the Disk Group Volume Target Selection panel.
If the select all option is selected then the summary is shown in the form of a grouping of source volumes and target disks. If the select all option is unchecked, the individual selected volumes and assigned target disks is displayed on the Summary panel.
The Save Summary option on the Summary panel lets you save user selection summary in an HTML file.
The default summary file name is StorageMigration_Summary_yyyy_MM_dd_HH_mm_ss.html.
The default location of the file is %allusersprofile%\veritas.
Verify that separate Subdisk move tasks are created per subdisk.
Click the Tasks tab on the VEA to check the tasks progress in the bottom panel of the console.
Wait for all Subdisk move tasks to complete.
From the Disk View tab verify that all selected volumes are now migrated to the selected destination disks.