This section provides information about removing a node or unconfiguring a CVM cluster using the CLI-based ffconfigcli utility.
Note: |
In the following commands, you can use the optional -verbose option at the end of a command to display information about the tasks that the command performs. |
Note: |
In the following commands, wherever the name of the node is required, you cannot optionally provide the node's IP address as it is not supported. |
For information about configuring a CVM cluster,
Unconfiguring a CVM cluster: Run the following command to unconfigure and delete a CVM cluster:
Note: |
It is recommended that you unconfigure the CVM cluster from the Microsoft failover cluster first, and then run this command. |
ffconfigcli -unconfigure
Removing a node from a CVM cluster: After removing a node from the Microsoft failover cluster, run the following command to remove it from the CVM cluster:
ffconfigcli -removenode <NodeName>
Where, <NodeName> is the name of the node that you want to remove from the CVM cluster. This is a mandatory parameter.
More Information