Configuring Microsoft Failover Clustering


Configuring Microsoft Failover Clustering
Prev	Microsoft Failover Clustering support	Next

To configure Microsoft Failover Clustering, you must perform the following steps:

Task	Reference
Step 1	For details about configuring Failover Cluster, refer to Microsoft documentation.
Step 2	For details about installing the product, refer to the Veritas InfoScale Installation and Upgrade Guide.
Step3

Task

Reference

Step 1

For details about configuring Failover Cluster, refer to Microsoft documentation.

Step 2

For details about installing the product, refer to the Veritas InfoScale Installation and Upgrade Guide.

Step3

Note:

SFW normally does not let you create a cluster dynamic disk group with the disks that are on the same bus as the cluster node's system or boot disk. To facilitate booting from a SAN, you can remove this limitation by running a vxclus command from the SFW command line interface.

Prev	Up	Next
Enabling Microsoft Failover Clustering after InfoScale Storage is already installed	Home	Create a cluster dynamic disk group