Configuring cluster quorum settings
The following procedure outlines the steps for configuring a clustered dynamic disk group resource.
Note: |
You must perform these tasks from a cluster node where all the cluster resources are online. If the clustered dynamic disk group resource is online on a node other than the one where rest of the cluster resources are online, you must move the clustered dynamic disk group resource to the other node and then perform these tasks.
To move the resource, right-click the resource and from the context menu select, Move > Best Possible Node.
|
To configure a clustered dynamic disk group resource
- From the Start menu (the Start screen on Windows 2012 operating systems), click .
To launch the Failover Cluster Manager snap-in, click .
- Right-click the cluster node and in the context menu, select > Configure Cluster Quorum Settings.
The Configure Cluster Quorum Wizard appears.
Click to continue.
- On the Select Quorum Configuration Option panel, select .
Click to continue.
- On the Select Quorum Witness panel, select and then click .
- On the Configure Storage Witness panel, select the disk group that is added for cluster quorum, and then click .
- Review the report that the wizard generates and click to complete the operation.
Confirm that the VMDg resource moves to "Cluster Group" along with Network Name and IP resources.
The wizard configures the cluster quorum settings.
The Volume Manager Disk Group that is created for cluster quorum is now added in the Failover Cluster as a quorum resource.
The quorum data is mirrored on all the disks that are part of the Volume Manager Disk Group. Even if any of the disks fail, the quorum data is available on the remaining disks.