If you are using a replication method that the DR wizard does not configure, you must select the replication option to configure global clustering only.
For the GCO only option, you use the wizard to complete all DR tasks except the replication configuration task. You must complete the final wizard task of configuring global clustering before configuring replication.
Before configuring GCO:
Ensure that you have one static address is available per site for configuring GCO.
If you created secure clusters at the primary site and secondary site, ensure that you have configured a VCS user with the same name and privileges in each cluster, and the user must be added in the Administrator role.
The following procedure assumes that you have completed the earlier wizard tasks through the service group cloning task and are continuing with the final step of configuring global clustering.
To configure GCO only
Otherwise, launch the wizard and proceed to the GCO Setup panel by following these steps sequentially:
Start the DR Configuration Wizard from the Solutions Configuration Center by clicking Start > All Programs > Veritas > Veritas Cluster Server > Solutions Configuration Center or, on Windows 2012 operating systems, from the Apps menu.
Expand the Solutions for Solutions for Additional Applications tab.
Click Disaster Recovery Configuration > Configure Disaster Recovery > Disaster Recovery Configuration Wizard.
In the Welcome panel, click Next and continue through the wizard, providing the requested information.
In the Replication Methods panel, click Configure Global Cluster Option (GCO) only. Click Next and continue to the GCO Setup panel.
If you want to change any of the parameters specified, click Back.
Otherwise, click Next.