Setting up your replication environment
Prev Deploying disaster recovery: New application installation Next

Setting up your replication environment

The DR wizard can assist you with setting up replication for the following methods of replication:

Note:

The DR wizard cannot be used if you are setting up DR in a non-shared storage environment.

For array-based hardware replication, you can use any replication agent supported by Cluster Server. The DR wizard can help with configuring the methods listed above. If you choose a different replication method, you must run the wizard first to complete configuring global clustering; then afterwards, you configure replication separately.

See Configuring global clustering only.

Before configuring replication with the wizard, ensure that you set up the replication environment prerequisites. Choose from the following topics, depending on which replication method you are using:

Prev Up Next
Verifying that your application or server role is configured for HA at the primary site Home Setting up security for Volume Replicator