 | ||
| Creating the Volume Replicator RVG service group for replication | ||
|---|---|---|
| Prev | Deploying disaster recovery: New application installation | Next |
| ||
| Creating the Volume Replicator RVG service group for replication | ||
|---|---|---|
| Prev | Deploying disaster recovery: New application installation | Next |
This is applicable only if you are setting up disaster recovery in a non-shared storage environment.
You cannot use the DR wizard to configure Volume Replicator replication if the service group contains VCS resources configured for non-shared storage (VMNSDg agent resources). You must configure the replication service group manually using the Cluster Manager (Java Console).
Complete the following procedures first on the node in the primary site. Then repeat all the steps on the node in the secondary site. You must follow the order of the procedures as mentioned.
Refer to the following topics:
See Configuring the VMDg or VMNSDg resources for the disk groups.
See Adding the Volume Replicator RVG resources for the disk groups.
See Linking the Volume Replicator RVG resources to establish dependencies.
See Deleting the VMDg or VMNSDg resource from the application service group.
See Linking the RVG Primary resources to establish dependencies.