Implementing a dynamic quorum resource
Prev Deploying SFW with Microsoft failover clustering Next

Implementing a dynamic quorum resource

Although Veritas recommends implementing a dynamic quorum resource in order to take full advantage of the Storage Foundation functionality, it is not a required task.

To implement a dynamic quorum resource, complete the following tasks:

Note:

If you are using DMP, you must create a dynamic quorum resource in order for the groups to fail over properly.

Note:

If you are planning to create a dynamic mirrored quorum for your Volume Manager Disk (VMDG) resource, then make your ClusSvc resource dependent on the VxBridge service. Refer to Microsoft documentation for details on creating resource dependencies. This dependency is required only in cases when you will reboot all the cluster nodes at the same time
Prev Up Next
Completing the setup of the application group in the failover cluster Home Creating a dynamic cluster disk group and a mirrored volume for the quorum resource