After configuring the cluster with SFW and the application on the primary site, follow the same procedures when configuring the secondary site. Follow the task list table.
See Tasks for deploying InfoScale Storage and Volume Replicator with Microsoft failover clustering.
In addition, note the following special requirements for configuring the secondary site:
During the creation of disk groups and volumes on the secondary site, make sure the following is exactly the same as the cluster on the primary site:
Before installing the application on the secondary site, offline all the resources in the failover cluster application group on the primary site, except the Volume Manager Disk Group resource.
After both clusters are running, one on the primary site and one on the secondary site, you can add the Volume Replicator components to the configuration.
See Part 3: Adding the Volume Replicator components for replication.