Synchronizing schedules after adding a cluster node

In a cluster environment, you may add a cluster node after you set up snapshot schedules with the Quick Recovery Configuration Wizard.

In such a case, you can ensure that the schedules are available on the new node by running the Quick Recovery Configuration Wizard again.

To synchronize schedules after adding a node:

  1. From the Start menu (the Start screen on Windows 2012 operating systems), type Run, and then press Enter to open the Run dialog box.

    In the Run dialog box, type scc, and then click OK to launch the Solutions Configuration Center (SCC).

    Launch the Quick Recovery Configuration Wizard from the Solutions Configuration Center.

  2. Continue through the wizard until the Synchronizing Schedules panel shows that synchronization between cluster nodes is complete.
  3. Click Cancel to exit the wizard.