Displaying an individual data volume or Replicator Log


Displaying an individual data volume or Replicator Log
Prev	Displaying information using the vxprint command	Next

Use the vxprint -l volume_name command to display information about a specific volume.

For more details on the volume-specific output fields, see Storage Foundation Administrator's Guide.

The output fields of special interest for Volume Replicator are shown in the following table:

Volume	Displays the name of the volume
info	Displays the length of the volume in bytes
assoc	Shows the RVG to which this data volume is associated
DriveLetter	Displays the drive letter of the specified volume
DeviceName	Displays the device name
VSS Snapshot	Displays whether the specified volume is a snapshot volume
state	Displays the state of the volume. For example, if the volume is accessible for Input/Output operations, the output field displays started.
Type	Displays the type of the volume, for example, Mirrored Concatenated.

Prev	Up	Next
Interpreting RVG flag settings	Home	Creating snapshots using the vxsnap command