Use the vrport heartbeat command to display or change the port number that Volume Replicator uses for heartbeats. Heartbeat messages use the UDP protocol.
To display the port number thatVolume Replicator uses for heartbeats, use the command
vrport heartbeat
To change the port number for heartbeats, use the command
vrport heartbeat port
Note: |
After changing the port number, the command displays a message asking you to restart the system. The changes take effect after the restart. |
To change the replication heartbeat port on a host from 4145 to 5000
vrport heartbeat 5000
Follow the above steps to change the heartbeat port on Secondary host.