To modify an existing resource in the replication service group, you need to perform the following.
To modify a resource in an existing replication service group
When you modify an existing replication service group, the Configure RVGPrimary resource for the selected RVG option is unavailable for selection.
Click Next.
Complete the IP Resource panel as follows:
Click Next to display the Network Configuration panel.
Complete the Network Configuration panel as follows depending on the option that you had chosen in the preceding panel:
If you had chosen the Create New IP resource on the preceding panel, then complete the panel as follows:
Virtual IP address |
Specify the virtual IP address in this field. Volume Replicatoruses this address for replication. |
Subnet Mask |
Enter the subnet mask that is provided in field provided. |
Adapter Display Name (Mac address) |
Specify the correct adapter name (Mac address) of each system to which you want to assign the IP resource and the corresponding NIC resource, in the Adapter Display Name column. |
If you had chosen any one of the options; to create a copy of an existing IP resource, link to an existing IP resource or modify an existing resource, then the panel is filled up as described in the following table. However, you can edit the information on this panel to change it to values that you require:
Virtual IP address |
Because the IP specified for replication has a resource that is created in the cluster, if copy option is selected, the wizard copies that IP and the corresponding NIC resource to the replication service group. If the link option is selected, then, the Network Configuration panel displays the value of the IP resource to which the selected RVG resource is linked. |
Subnet Mask |
If the resource for the IP already exists then the wizard disables the Subnet Mask field and other inputs as these values are taken from the existing IP resource. If no resource has been created for the specified IP then you can enter a subnet mask value and choose the proper adapter on each system. |
Adapter Display Name (Mac address) |
The appropriate adapter name (Mac address) is displayed for each system. |
A warning informing you that the service group will be created is displayed. Click Yes to proceed.