The following sections give a checklist that can be used to troubleshoot the RLINKs that are not connected.
You may need to do certain configuration checks if you have created an RDS or changed some setting in the configuration through the CLI.
You may need to perform the following:
On all nodes participating in the replication, run the following command:
vxprint -lPV
In the output, check for the following:
Check whether the RLINKs are active or stale. For replication to begin they must be active.
Primary remote_rlink = Secondary rlink name.
Secondary remote_rlink = Primary rlink name.
Primary remote_dg = Secondary dg.
Secondary remote_dg = Primary dg.
Primary local_host = Secondary remote_host.
Secondary local_host = Primary remote_host.
Primary remote_host IP is indeed the IP of the Secondary host.
Secondary remote_host IP is indeed the IP of the Primary host.
Verify that the Primary RLINK is ACTIVE.