About disabling DMP for vSCSI devices in the logical partition (LPAR)


About disabling DMP for vSCSI devices in the logical partition (LPAR)
Prev	Using Storage Foundation in the logical partition (LPAR) with virtual SCSI devices	Next

DMP can co-exist with MPIO multi-pathing in the Virtual I/O client or logical partition (LPAR). To use MPIO for multi-pathing, you can override the default behavior which enables Dynamic Multi-Pathing (DMP) in the LPAR.

There are two ways to do this:

Before you install or upgrade Storage Foundation in the Virtual I/O client

See Preparing to install or upgrade Storage Foundation with DMP disabled for vSCSI devices in the logical partition (LPAR).
After Storage Foundation is installed in the Virtual I/O client

See Disabling DMP multi-pathing for vSCSI devices in the logical partition (LPAR) after installation or upgrade.

Prev	Up	Next
Setting up DMP for vSCSI devices in the logical partition (LPAR)	Home	Preparing to install or upgrade Storage Foundation with DMP disabled for vSCSI devices in the logical partition (LPAR)