By default, SFDB tools are disabled that is the vxdbd daemon is not configured. You can check whether SFDB tools are enabled or disabled using the/opt/VRTS/bin/sfae_config status command.
To enable SFDB tools
- Log in as root.
- Run the following command to configure and start the vxdbd daemon. After you perform this step, entries are made in the system startup so that the daemon starts on a system restart.
#/opt/VRTS/bin/sfae_config enable
To disable SFDB tools
- Log in as root.
- Run the following command:
#/opt/VRTS/bin/sfae_config disable