To configure LLT, GAB, VCSMM, and VXFEN drivers
/etc/llthosts
on the two existing systems. Using vi
or another text editor, add the line for the new node to the file. The file should resemble:
/etc/llthosts
file from one of the existing systems over to the new system. The /etc/llthosts
file must be identical on all nodes in the cluster.
/etc/llttab
file on the new system. For example:
link en1 /dev/dlpi/en:1 - ether - -
link en2 /dev/dlpi/en:2 - ether - -
The second line, the cluster ID, must be the same as in the existing nodes.
vi
or another text editor to create the file /etc/gabtab
on the new system. It should resemble the following example:
Where N represents the number of systems in the cluster. For a three-system cluster, N would equal 3.
/etc/gabtab
file on each of the existing systems, changing the content to match the file on the new system.
/etc/vcsmmtab
and /etc/vxfendg
files on the new system by copying them from one of the other existing nodes:
/etc/vxfenmode file
to enable fencing. Use the commands in the order shown: