Environment Variable
|
Definition and Default Value
|
vcs_conf
|
Root directory for VCS configuration files.
Default: /etc/VRTSvcs
Note
If this variable is added or modified you must reboot the system to apply the changes.
|
vcs_domain
|
The Security domain in which users are configured.
|
vcs_domaintype
|
Type of domain: unixpwd, nt, nis, nisplus, or vx.
|
vcs_diag
|
Directory where VCS dumps HAD cores.
|
vcs_enable_ldf
|
Designates whether or not log data files (LDFs) are generated. If set to 1, LDFs are generated. If set to 0, they are not.
|
vcs_home
|
Root directory for VCS executables.
Default: /opt/VRTSvcs
|
vcs_host
|
VCS node on which ha commands will be run.
|
vcs_gab_port
|
GAB port to which VCS connects.
Default: h
|
vcs_gab_timeout
|
Timeout in milliseconds for HAD to send heartbeats to GAB.
Default: 15000
Note
If the specified timeout is exceeded, GAB kills HAD, and all active service groups on system are disabled.
|
vcs_had_restart_timeout
|
Set this variable to designate the amount of time the hashadow process waits (sleep time) before restarting HAD.
Default: 0
|
vcs_log
|
Root directory for log files and temporary files.
Default: /var/VRTSvcs
Note
If this variable is added or modified you must reboot the system to apply the changes.
|
vcs_service
|
Name of configured VCS service.
Default: vcs
Note
The specified service should be configured before starting the VCS engine (HAD). If a service is not specified, the VCS engine starts with port 14141.
|
vcs_temp_dir
|
Directory in which temporary information required by, or generated by, hacf is stored.
Default: /var/VRTSvcs
This directory is created in /tmp under the following conditions:
-
The variable is not set.
-
The variable is set but the directory to which it is set does not exist.
-
The utility hacf cannot find the default location.
|